Sikafloor®-161 HC Screed

24 months from date of production

The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +18 °C and +30 °C.

~2.0 kg/L for finished screed

+10 °C to +30 °C

Substrate temperature must be 3 °C above measured dew point

Maximum moisture content of substrate: < 4 %

15 min (+30 °C)

Notes: Times are approximate and will be affected by changing ambient and substrate conditions.

Primer :

Screed :

• Stir Component A thoroughly with an electric stirrer prior to batching.
• Add Component B in the correct mix ratio and mix for 2-3 minutes at a low speed.
• Place the correctly batched quantity of Component C in the mixer (forced action type).
• Add the prepared resin mix (Components A + B) while the mixer is running, and continue to mix until a homogeneous and uniformly moist mix is obtained.

Place the mortar while the primer coat is still tacky, and rake out evenly (Always apply “wet on wet” over Sikafloor®161 HC Primer). Tamp down with a beam laid across steel screeding rails and finish with a steel float.

Clean all tools and equipment immediately after use with Colma Cleaner or Thinner C. One hardened, the material can only be removed mechanically. Wash soiled hands and skin thoroughly in hot soapy water