Sika MonoTop®-613 IND

9 months from date of production if stored properly in unopened original packing

Store in dry, cool and shaded place

~2.05 kg/L (density of fresh mortar)

Water : Powder = 1 : 7.3 - 8.1 parts by weight

(i.e. approx 3.25 L water per 25 kg bag)

Minimum 5 mm / Maximum 40 mm

Minimum +5 ˚C / Maximum +35 ˚C

For 1 litre of fresh mortar: 1.85 – 1.9 kg powder are required. Material consumption depends on concrete surface and application method. On level substrate consumption is approx. 18.5 – 19.5 kg of dry mortar (powder) per m² at 10 mm layer thickness.

Pour water in given quantity into the mixing container. Add powder while mixing continuously. Use low speed electric mixers (max. 500 rpm) for 3 minutes avoiding entrapping of air. By adding the powder in portions, the desired application consistency can be obtained.

Sika MonoTop®-613 IND can be applied with spatula or trowel. The mortar is applied on well-saturated concrete substrate. For thickness greater than 40 mm Sika MonoTop®-613 IND must be applied in several layers. As soon as the mortar has started to set it can be smoothed by wooden or synthetic float or a styrofoam block.

NOTES
No additional water must be used.
To achieve good bonding it is recommended to apply SikaTop 121 as bonding coat especially on large area application Sika MonoTop®-613 IND cures with low shrinkage.
To prevent premature drying out of the mortar, keep it moist if exposed to strong sunshine or wind. Standard curing methods are recommended.
For very fine surface finish, the application of SikaTop 121 as filling compound on top of Sika MonoTop®-613 IND is advised.

Application and mixing tools should be cleaned with water while material is still fresh. Hardened material can only be removed mechanically.