Sika® Repair Mortar ID

9 months from the date of production if stored in undamage and unopened original sealed bags

Store in dry condition between +10 °C - +30 °C

~2.21 kg/L

0.8 L per 5 kg bag (water per powder = 16 % by weight)

Recommended thickness is 20 - 100 mm

< 30 °C, max.

+10 °C - +35 °C

+10 °C - +35 °C

25 min

4 - 8 h

~1 905 kg/m³ of mortar

2.62 L per 5 kg bag

Put appropriate quantity of water (depend on the required consistency) into a mixing vessel. Add slowly the total contents of Sika® Repair Mortar ID while mixing. Mix continuously for 3 minutes to achieve an even consistency. Use a mechanically low speed drill (400–600 rpm) with helical type mixing paddle or appropriately sized mortar mixer.

Within 25 minutes after mixing, place grout into forms from one side to avoid air entrapment. Do not vibrate. Use a suitable head box of 150–200 mm and maintain the grout head at all times to ensure a continuous
flow. Gentle tapping or pulling loops of wire from one side may assist the flow of the mortar under difficult working conditions.

Wet cure for a minimum 3 days with wet hessian, plastic sheet or apply a curing compound (Antisol)

Clean all tools and application equipment with water immediately after use. Hardener and/or cured material can only be remove mechanically.