SikaTop®-107 Seal ID

9 months from the date of production when stored in undamaged and unopened original container.

Store in dry, cool, and shaded place conditions at temperatures between +5 °C and +30 °C.

2.1 – 2.2 kg/L (part A + B mixed)

~60 minutes (at +30 °C)

Depending on type of application, 2 coats always required 1 - 1.5 kg/m² per coat.

Pour 90% of component A (liquid) into mixing vessel. Add all component B (powder) and mix until you have slurry of uniform consistency. Add rest of component A and mix again until you have uniform, lump-free mixture. A mechanical slow speed mixer is recommended. Mixing time 2-3 minutes. If SikaTop®-107 Seal ID is to be applied by trowel, use only 90% of component A (liquid).

By brush:

On vertical surface use suitable brush with synthetic bristles. On horizontal surface use rubber slide or push-broom.

By trowel:

• Use flat trowel to distribute SikaTop®-107 Seal ID into prepared substrate with consumption 1 - 1.5 kg/m² per coat. Always apply a minimum of 2 coats.
• The first coat has to be applied on the damp substrate (pre-wetted).
• The second coat will be applied after the first coat started to set and can support the following coat, usually after 2-6 hours depending on climate.
• Finish off by brushing with dry sponge when setting of second coat has started.
• Maximum waiting time between first and second coats is 48 hours.
• Use Sika reinforcement membrane when necessary at corner and detailing area.

As with all cement based products, curing is important. Protect the freshly applied product against direct sunlight and strong winds. Use damp hessian or plastic sheet. Protect the applied SikaTop from rain and water splashes until fully hardened. (± 6 hours).